The device has numerous other improvements over previous designs, including a broadband four-layer anti-reflection coating, a novel metamorphic tunnel junction interconnect, and unprecedented performance from the GaInP top cell. The cell’s peak efficiency of 45.7 ± 2.3 percent was measured under the AM1.5 direct spectrum at 234 suns concentration, but the device performs nearly as well at even higher concentrations, having 45.2 percent efficiency at 700 suns concentration. The new design consists of a gallium indium phosphide (GaInP) junction, a gallium arsenide junction, and two gallium indium arsenide junctions that are lattice-mismatched to the substrate. NREL invented and developed the advanced four-junction inverted metamorphic (4J IMM) cell with these challenges in mind. NREL has learned to control and confine these dislocations to inactive regions of the device, allowing even highly mismatched material to be used in a multijunction cell.” “Lattice-mismatched materials require the introduction of defects, called dislocations, into the device, which can drastically hinder device performance. “The distinction of this multijunction device is the very high quality of the lattice-mismatched subcells,” said NREL Scientist Ryan France, designer of the solar cell. The challenge is to maintain the high quality of the materials while integrating them into a complex cell capable of efficient photoconversion. Combining materials with optimal bandgaps is critical for high efficiency. Multijunction solar cells harvest sunlight by dividing the solar spectrum into portions that are absorbed by a material with a bandgap tuned to a specific wavelength range. NREL’s new solar cell, which is designed for operation in a concentrator photovoltaic (CPV) system where it can receive more than 1,000 suns of concentrated sunlight, greatly improves earlier designs by incorporating an additional high quality absorber layer to achieve an ultra-high efficiency. This achievement represents one of the highest photovoltaic research cell efficiencies achieved across all types of solar cells. The Energy Department’s National Renewable Energy Laboratory has announced the demonstration of a 45.7 percent conversion efficiency for a four-junction solar cell at 234 suns concentration.
New design for ultra-efficient III-V multijunction cell pushes the limits of solar conversion.
0 kommentar(er)
